The EDM-800 instrument has all the advanced functions of the EDM-700, but incorporates some new features that can only be found on JPI products. No longer do pilots have to waste time looking up and guesstimating the present percentage of horsepower (HP). There are new easy readable digits located at the top of the EDM display which continually show the percentage of horsepower being used, & can also display RPM. What is unique about this new feature is that it can also display HP over lean. HP can be displayed for either carbureted or injected engines, even if they are turbocharged. Now you can be sure that you are within the horsepower limits of your engine, and in IFR conditions, this can be quite a task. At the present time HP is only available on single engine 4 and 6 cylinder engines. The EDM800 calculates percent of horsepower in an Over lean condition. Lycoming & Contentinal horsepower charts stop at peak EGT on the first cylinder to peak. Gami has developed a method of going over lean on all cylinders. When you are over lean, every ounce of fuel is burned & used to create horsepower and heat. Cooling is accomplished by excess air in the combustion chamber. JPI has developed an algorithm to calculate horsepower based on fuel consumption and other factors. To obtain HP in this over lean condition you must have an EDM-800 engine analyzer with fuel flow, RPM, MAP, OAT, Memory & Gami tuned injectors. In addition to JPI's HP function, EDM800 also has a Memory Module that can store up to 25 hrs. of engine data, which can be downloaded to a laptop or palmtop PC. When using the memory function, all functions of the EDM will be recorded, including Fuel Flow & HP.

EDM-800 includes:

• Continuous display of %HP or RPM.
• RPM & Manifold pressure on main
display when %HP is displayed.
• Leaning Rich of peak displays bar
graph Histogram of each peak and
fuel flow differential (Gami Spread)
when last cylinder peaks.
• Linerized accuracy of 1º, not 10º.
• DigiScan® Fuel Flow, years ahead
of all other monitors with this feature.
Works with all GPS including
handheld.

• LeanFind mode automatically identifies
the first and last cylinder to peak and
PeakFind automatically captures the
EGT peak value.
• Full FAA approved with STC and TSO,
not PMA.
• EDM-800's come complete with probes
and sensors to measure RPM, MAP,
OAT, Fuel Flow and Memory.
• TSO Quality with two year warranty
• EZEREC® Records up to 25 hours of
flight data in long-term memory (optional).